Tilt 5-related CAD files



  • Kasper provided in Discord marker placement data for LE board:

    4x12 (x,y) pairs in metric / meter, centered on origin 0,0

    +0.350, +0.375, +0.241, +0.375, +0.204, +0.375, +0.167, +0.375, +0.112, +0.375, +0.075, +0.375, -0.052, +0.375, -0.089, +0.375, -0.135, +0.375, -0.181, +0.375, -0.264, +0.375, -0.350, +0.375, -0.375, +0.350, -0.375, +0.266, -0.375, +0.223, -0.375, +0.158, -0.375, +0.094, -0.375, +0.039, -0.375, -0.034, -0.375, -0.071, -0.375, -0.153, -0.375, -0.190, -0.375, -0.227, -0.375, -0.350, -0.350, -0.375, -0.232, -0.375, -0.195, -0.375, -0.149, -0.375, -0.094, -0.375, -0.048, -0.375, +0.025, -0.375, +0.062, -0.375, +0.153, -0.375, +0.190, -0.375, +0.241, -0.375, +0.350, -0.375, +0.375, -0.350, +0.375, -0.296, +0.375, -0.186, +0.375, -0.122, +0.375, -0.076, +0.375, -0.029, +0.375, +0.088, +0.375, +0.125, +0.375, +0.162, +0.375, +0.209, +0.375, +0.286, +0.375, +0.350

    I cannot attach the DIY DXF here, insufficient privilege.



  • The values above are used in firmware for the original (rigid) prototype boards.

    The early cardboard and current vinyl LE foldable boards had two markers moved because of the folds/cuts:

    +0.375, -0.122, becomes +0.375, -0.118,
    +0.375, +0.125, becomes +0.375, +0.119,

    If you put the LE board with the T5 logo in the lower right corner, these two markers are near the folds on the right-hand edge.


Log in to reply